A wooden storage bench with cushion, offers a place to sit at your entrance to remove your jacket and wet shoes. Cut the plywood into five parts, each 16 inches wide. Two pieces must be equal to the width of the joint. Two pieces should measure more than 16 inches by 14.5 inches and the final piece should measure 16 inches by the width of select. Adjust the end piece of the side plywood for the time being. Give it a box shape with the other four pieces.
Apply the spray adhesive to the top plate or top of the bench with cushion. Press firmly the polyurethane filler to the joint, aligning the filler edges to the edge of the board. Let the glue dries. Cut the fabric to the size of the top, allowing enough to cover the sides and by 3 inches inside the edge of the cover plate.
Place the face of the fabric on the floor or a table. Put the batting on top of the fabric. Spray the top of the polyurethane filler with adhesive. Keep the table face up, place the filler and the board on top of the wadding and fabric layer. Principle in the middle of one side. Pull the fabric over the filling, stapling to the bottom of the wooden board. Continue stapling around it, about an inch away.